Remove

SCPI Command :

[SOURce<HW>]:AREGenerator:OSETup:MULTiinstrument:SECondary:REMove

class RemoveCls

Remove commands group definition. 1 total commands, 0 Subgroups, 1 group commands

set() → None

# SCPI: [SOURce<HW>]:AREGenerator:OSETup:MULTiinstrument:SECondary:REMove
driver.source.areGenerator.osetup.multiInstrument.secondary.remove.set()

Removes the secondary instrument from connected R&S AREG800A instruments that are listed in the primary instrument. Also, this command terminates the control connection between primary instrument and the secondary instrument. The firmware saves hostname of the secondary instrument for correct mapping. For example, if you want to add the secondary instrument again.

set_with_opc(opc_timeout_ms: int = -1) → None

# SCPI: [SOURce<HW>]:AREGenerator:OSETup:MULTiinstrument:SECondary:REMove
driver.source.areGenerator.osetup.multiInstrument.secondary.remove.set_with_opc()

Removes the secondary instrument from connected R&S AREG800A instruments that are listed in the primary instrument. Also, this command terminates the control connection between primary instrument and the secondary instrument. The firmware saves hostname of the secondary instrument for correct mapping. For example, if you want to add the secondary instrument again.

Same as set, but waits for the operation to complete before continuing further. Use the RsAreg800.utilities.opc_timeout_set() to set the timeout value.

param opc_timeout_ms:

Maximum time to wait in milliseconds, valid only for this call.